---
title: "SKP Connector 1.1.12 (and above) Post Installation Steps"
slug: "skp-connector-1110-post-installation-steps"
updated: 2025-07-29T18:54:14Z
published: 2025-07-29T18:54:14Z
canonical: "skthelp.syniti.com/skp-connector-1110-post-installation-steps"
---

> ## Documentation Index
> Fetch the complete documentation index at: https://skthelp.syniti.com/llms.txt
> Use this file to discover all available pages before exploring further.

# SKP Connector 1.1.12 (and above) Post Installation Steps

Manual changes to be applied post installation or upgrade of the SKP Connector.

## Overview

Changes have been made to the SKP Connector in the 1.1.12 release that allow for the specification of the Maximum Transmission Unit (MTU) size within the */etc/syniti-rdc/config.hcl* file. The editing of the config file must be applied manually after the installation or upgrade to the SKP Connector has completed.

### Update the Config File

Follow the steps below to apply the changes to the config file and then restart the SKP Connector service to pick up the MTU settings.

1. Run the install / upgrade process for the 1.1.12 release of the SKP Connector relevant to your operating system (e.g. *sudo bash syniti_install_rhel9.sh -u* for a North American tenant with the connector running on Redhat 9.3). On successful installation, move to the next step.
2. Run the vi command *vi /etc/syniti-rdc/config.hcl.*
3. In the file, add *mtu = 1280* to the bottom of the file below the *interface = “wg0”* line. Once updated, it should look like the following:
4. # Default: wg0 interface = "wg0" mtu = 1280
5. Save the file.
6. Stop and start the service with the following commands:

sudo systemctl stop syniti-rdc sudo systemctl start syniti-rdc

This completes the change to the configuration of the SKP Connector to utilize the new MTU settings.